The DEFINITIVE SOLUTION to permanently terminating magnet wire.
Patent Pending
NOW  Reliably terminate your magnet wire WITHOUT striping or preparing it in any way except locating it on your terminal.
ONE STEP, Strip, and WELD or Solder the wire to the terminal. DONE.
Our PATENT Pending Process conveniently strips the wire ULTRASONICALLY and then Resistance Welds or Solder Reflows the wire to the terminal.
So What do these welders do that other welders can NOT do?
Our Patent Pending process SCRUBS thru the enamel insulation on magnet wire, then we Resistance Weld that wire to the terminal.
2 seconds- DONE
No scraping the insulation off, No burning the insulation off, NO REMOVING THE INSULATION AT ALL !!!!!!!
OUR PROCESS REMOVES THE INSULATION AND WELDS THE WIRE
IN ONE EASY,  QUICK STEP.
So Where would I use this thing???
Do you make coils?
Do you make windings?
Do you make motors?
Do you have to terminate or connect to any enamel, shellac, lacquer, polyurethane or paint coated wire?
If you answered YES to any of the above,
CALL 941-223-7678